UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 379
Description
Use Program 24-02 : System Options for Transfer to define the system options for
the Transfer feature.
Program 24 : Hold/Transfer Setup
24-02 : System Options for Transfer
Level:
IN
Input Data
Item
No.
Item Input Data Default
Related
Program
01
Busy Transfer
Use this option to prevent or allow extensions to
Transfer calls to busy extensions. If disabled,
calls transferred to busy extensions recall
immediately.
0 =Disable
(No)
1 = Enable
(Yes)
0 (OT)
1 (AU)
02
MOH or Ringback on Transferred Calls
Use this option to enable or disable MOH on
Transfer. If enabled (0), a transferred caller
hears MOH while their call rings the destination
extension. If disabled (1), a transferred caller
hears ringback while their call rings the
destination extension.
0 = Hold Tone
1 = Ring Back
Tone
0 20-03-02
03
Delayed Call Forwarding Time
If activated at an extension, Delayed Call
Forwarding occurs after this time. This also sets
how long a Transferred call waits at an
extension forwarded to Voice Mail before routing
to the called extension mailbox.
0~64800s
10 20-31-15
04
Transfer Recall Time
An unanswered transferred call recalls to the
extension that initially transferred it after this
time.
0~64800s
30 20-31-16
05
Message Wait Ring Interval Time
For Single Line Telephones (SLTs) without
message waiting lamps, this is the time between
intermittent ringing. If this value is set to 0, the
system rings once.
0~64800s
30
To Next Page
Loading...
