NEC Univerge SV8100 - 12-01: Night Mode Function Setup; Program 12: Night Mode Setup

Programming Manual 2 - 127
Program
12
Description
Use Program 12-01: Night Mode Function Setup to set up the Night Mode
options. Refer to the following chart for a description of each option, its range
and default setting.
Conditions
None
Feature Cross Reference
 Night Service
Program 12 : Night Mode Setup
12-01: Night Mode Function Setup
Level:
IN
Input Data
Item
No.
Item Input Data Default Description
Related
Program
01
Manual Night
Mode Switching
0 = Off
1 = On
1
Allow/Prevent as activating
Night Service by dialing a
service code.
11-10-01
02
Automatic Night
Mode Switching
0 = Off
1 = On
1 (OT)
0 (AU)
According to a preset
schedule, enable or disable
Automatic Night Service for
the system.
12-02
12-03
12-04
03
Night mode
switch operating
mode
0 = Not used
1 - 8 (Operation
Mode1 - 8)
0
Use this option to set the
operation mode of the CPU
Night Service mode switch
sensors (external Night
Mode Selector Switch). The
Night Service mode affects
trunk inbound and outbound
routing.
04
General Purpose
Contact Detector
When 49-06 is set
this set will ignore
the 49-06 setting.
0 = Not used
1 - 1 = Detector
Number
0
Set the detection circuit of
the general purpose relay of
the PGD Adapter when
switching night mode
(Program 10-41).
10-41
 Even if the operation mode is changed manually, the operation mode changes according to the
schedule set up.