UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 407
Description
Use Program 26-02 : Dial Analysis Table for ARS/LCR to set pre-transaction tables
for selecting Automatic Route Selection (ARS).
Service Type 1 (Route to Trunk Group Number) – The number routes to a trunk
group.
Service Type 2 (F-Route Selected) – The number is controlled by the F-Route table.
Program 26 : ARS Service & Least Cost Routing
26-02 : Dial Analysis Table for ARS/LCR
Level:
IN
Input Data
Dial Analysis Table Number 1~800
Item
No.
Item Input Data Default
Related
PRG
01
Dial
Dial Digits (16 digits maximum)
1~9, 0,
, #, or for wild character (Press line
key 1)
No
Setting
02
ARS Service
Type
0 = No Service (None)
1 = Route to Trunk Group
2 = Select F-Route Access
0
03
Additional
Data / Service
Number
If Service Type 1 (in 26-02): Select Trunk
Group Number
0~100 (Trunk Group No.0= No Route)
101~150 (Networking ID) (OT)
If Service Type 2 (in 26-02-02):
F-Route Time Schedule Not Used = 0~500
(F-Route Table Number).
Refer to Program 44-05: ARS/F-Route Table
on page 2-537.
F-Route Time Schedule Used = 0~500
(F-Route Selection Number).
Refer to Program 44-04: ARS/F-Route
Selection for Time Schedule on page
2-536.
0 44-04
44-05
To Next Page
Loading...
