NEC Univerge SV8100 - 22-09: DID Basic Data Setup

Issue 10.1 UNIVERGE SV8100
2 - 352 Program 22 : Incoming Call Setup
Description
Use Program 22-09: DID Basic Data Setup to define the basic setting of Dial-In
incoming calls for each trunk group.
Program 22 : Incoming Call Setup
22-09: DID Basic Data Setup
Level:
IN
Input Data
Trunk Group Number 001~100
Item
No.
Item Input Data Default
01
Expected Number of Digits
Enter the number of digits the table
expects to receive from the telco. Use this
program to make the system compatible
with 3- and 4-digit DID service.
If ISDN trunks, we analyze the last digits
that are set here. If it is T-1 or analog DID,
it analyzes the first digits that are assigned
here.
1~8
4 (OT)
2 (AU)
02
Received Vacant Number Operation
Use this option to enable or disable
Vacant Number Intercept.
0 = Disconnect (Cut)
1 = Transfer (Refer to
Program 22-12: DID
Intercept Ring Group on
page 2-361.)
0
03
Sub-Addressing Mode
0 = Extension # Specify
(Intercom)
1 = DID Conversion Table
0
04
DID Receiving Mode for ISDN
0 = Enbloc Receiving
1 = Overlap Receiving
0
05
Local Code Digits
(Only Overlap Receiving Mode)
0~15 (0 = No Local Code)
0
06
Local Code
(Only Overlap Receiving Mode)
Dial (maximum 16 digits)
No Setting
07
Pilot Code
(Only Overlap Receiving Mode)
Dial (1 digit: 0~9)
No Setting