UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 167
Description
Use Program 14-11: ID Setup for IP Trunk to set the ID of each IP Trunk. This
program refers to incoming and outgoing IP Trunk calls. The ID is sent on an outgoing
IP Trunk call. This program is used only for H.323.
Conditions
This Data is referred to at IP trunk outgoing call, or IP trunk incoming call.
This ID is notified at IP trunk outgoing call.
It is not notified when ID is 0.
Incoming Call arrives to the trunk port of the same ID as ID notified from the
partner system.
Feature Cross Reference
IP Trunk – H.323 (OT)
Program 14 : Trunk, Basic Setup
14-11: ID Setup for IP Trunk
Level:
IN
Input Data
Trunk Port Number 001~200
Item No. Item Input Data Default
01 IP Trunk ID
0~65535
(0 = No setting)
0
To Next Page
Loading...
