UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 861
Description
(This program is available only via telephone programming and not through PC
Programming).
Use
Program 90-04: Load Data to load the system data from the inserted USB Flash
Drive to the SRAM and Flash ROM in the system.
Conditions
After uploading the programming, reset the system and wait a few minutes for the
system to reset completely before accessing any line or special system feature.
Otherwise, some unusual LED indications may be experienced.
Feature Cross Reference
None
Program 90 : Maintenance Program
90-04: Load Data
Level:
SA
Input Data
Item
No.
Item Input Data
01
Load Data
Dial 1+ press Transfer (Press Transfer to cancel.)
To Next Page
Loading...
