NEC Univerge SV8100 - Call Forward Split Settings

Issue 10.1 UNIVERGE SV8100
2 - 384 Program 24 : Hold/Transfer Setup
Description
Use Program 24-09: Call Forward Split Settings to assign Call Forwarding Type
and the destination number for each extension/virtual extension. The destination can
have up to 24 digits, using 0~9,
, #, P, R and @. Be sure to include the trunk access
code (e.g., 9) in the number if the destination is off-premise.

Pause can be set by LK 1.
Program 24 : Hold/Transfer Setup
24-09 : Call Forward Split Settings
Level:
IN
Input Data
Extension Number Maximum eight digits
Item
No.
Input Data Default
01
Call Forwarding Type:
0 = Call Forwarding Off
1 = Call Forwarding with both ring
2 = Call Forwarding when no answer
3 = Call Forwarding all calls
4 = Call Forwarding busy or no answer
5 = Call Forwarding when busy
0
02
CO Call Forwarding Destination for Both Ring, All Call, No Answer:
1~9, 0, #,
, P, R, @
(Up to 24 digits)
 Only ISDN uses the @ symbol
No
Setting
03
Intercom Call Forwarding Destination for Both ring, All Call, No
Answer:
1~9, 0, #,
, P, R, @
(Up to 24 digits)
No
Setting
04
CO Call Forwarding Busy Destination:
1~9, 0, #,
, P, R, @
(Up to 24 digits)
No
Setting
05
Intercom Call Forwarding Busy Destination:
1~9, 0, #,
, P, R, @
(Up to 24 digits)
No
Setting