NEC Univerge SV8100 - Toll Restriction Table Data Setup

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 321
Description
Use Program 21-06: Toll Restriction Table Data Setup to set the system Toll
Restriction data. Dial 1-9, 0,
, # can be entered in each table.
Program 21 : Outgoing Call Setup
21-06 : Toll Restriction Table Data Setup
Level:
IN
Input Data
Item
No.
Item Table Input Data Default Description
01
International Call
Restriction Table
1~10
Dial
(Up to four
digits)
Tables 1~10 = No
Setting
This option lets you program the
Restrict Table for international
calls. The system has 10
International Call Restrict Tables.
Each entry can have up to four
digits.
02
International Call
Permit Code
Table
1~20
Dial
(Up to six
digits)
Tables 1~20 = No
Setting
This option lets you program the
Permit Table for international calls.
The system has 20 International
Call Permit Tables. Each entry can
have up to six digits.
03
Maximum
Number Digits
Table
Assignment
1~4
4~30
Tables 1~ 4 = 30
This option selects the maximum
number of digits allowed in
outgoing calls for each table.
04
Common Permit
Code Table
1~10
Dial
(Up to four
digits)
No Setting (OT)
Table1 = 000 (AU)
Table 2 ~ 10 = No Setting
(AU)
This option lets you program the
Common Permit Code Table. This
table contains up to 10 codes you
commonly allow users to dial.
05
Common
Restriction Table
1~10
Dial
(Up to 12
digits)
No Setting
This option lets you program the
Common Restrict Code Table. This
table contains up to 10 codes you
commonly prevent users from
dialing.
06
Permit Code
Table
1
~4
(table)
001
~200
(Entry)
Dial
(Up to 12
digits)
Table 1~4 = No Setting
This option lets you program the
Permit Code Tables. If the system
has Toll Restriction enabled, users
can dial numbers only if permitted
by these tables and the Common
Permit Table (21-06-04). There are
four Permit Code Tables, with up to
200 entries in each table. The
system permits calls exactly as you
enter the code.