NEC Univerge SV8100 - Page 358

Issue 10.1 UNIVERGE SV8100
2 - 322 Program 21 : Outgoing Call Setup
Conditions
None
Feature Cross Reference
None
07
Deny Restriction
Table
1
~4
(table)
1
~60
(Entry)
Dial
(Up to 12
digits)
Table 1~4 = No Setting
This option lets you program the
Restrict Code Tables. If the system
has Toll Restriction enabled, users
cannot dial numbers listed in these
tables. There are four Restrict
Code Tables, with up to 200 entries
in each table. The system restricts
calls exactly as you enter the code.
08
PBX Access
Code
1
~4
Dial
(Up to two
digits)
Table 1~4 = No Setting
Use this option to enter the PBX
Access Code. When the system is
behind a PBX, this is the code
users dial to access a PBX trunk.
Toll Restriction begins after the
PBX access code. For PBX trunks
(Program 14-04) the system only
Toll Restricts calls that contain the
access code. Always program this
option when the system is behind a
PBX, even if you don’t want to use
Toll Restriction. PBX Access
Codes can have up to two digits,
using 0-9, #,  and LINE KEY 1
(don’t care). When using Account
Codes, do not use an asterisk in a
PBX access code. Otherwise, after
the , the trunk stops sending
digits to the central office. Entries
1~4 correspond to the 4 PBX
Access Codes. Each code can
have up to two digits.
09 Specific Dial
Outgoing Code
1
~20
Dial
(Up to eight
digits)
No Setting
10 Outgoing Call
Code Setup
1
~20
Dial
(Up to four
digits)
No Setting
Input Data
Item
No.
Item Table Input Data Default Description