NEC Univerge SV8100 - SIP System Information Setup

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 47
Description
Use Program 10-28 : SIP System Information Setup to set up basic SIP trunking.
Program 10 : System Configuration Setup
10-28 : SIP System Information Setup
Level:
SA
Input Data
Item
No.
Item Input Data Default
01
Domain Name
Set the domain name of the SIP-
URL.
Up to 64 Characters
(ex.:UserID@HostName.DomainName)
None
02
Host Name
Set the host name of the SIP-
URL.
Up to 48 Characters
(ex.:UserID@HostName.DomainName)
None
03
Transport Protocol
Set the protocol for the
connection.
0 = UDP
1 = TCP
0
04
UserID
User ID in the SIP Invite Setup
message. Use it for outbound
caller ID information if no
information is assigned in
commands 21-17, 21-19, 15-16,
14-12, and 10-36. A call cannot be
completed across the span if there
is no outbound CID info. The
reason for this is: the from and
display portion of the invite
message would be blank, and it
would not know where the call
originated from.
Up to 32 Characters
When assigning the User ID, the ID may
contain only alpha characters. (A space
and/or special characters are not allowed
in the User ID field).
(ex.:UserID@HostName.DomainName)
None
05
Domain Assignment
If the information from Telco was a
domain name (siptrunk@sip.com)
then set to domain. If the
information for Telco was a IP
address then set to IP Address.
0 = IP Address
1 = Domain Name
0