NEC Univerge SV8100 - 50-02: Connecting System Settings

Issue 10.1 UNIVERGE SV8100
2 - 624 Program 50 : Common Channel Interoffice Signaling Service
Description
Use Program 50-02: Connecting System Settings to define the settings for
each CCIS Route ID.
Program 50 : Common Channel Interoffice Signaling Service
50-02: Connecting System Settings
Level:
IN
Input Data
CCIS Route ID Route ID 1~8: CCIS via DTI
Route ID 9: CCIS via IAD/CD-PVAA (IP-CCIS)
Item
No.
Item Description Input Data Default
01
Port Number of Common
Signaling Channel (T1)
Specify the Trunk port to send D-
channel information. This program
is available for using DTI package.
0~200
0
02
Common Signaling
Channel Data Speed
Assignment (T1)
Assign the baud rate of Common
Signaling Channel on DTI
package.
0 = 64Kbps
1 = 56Kbps
2 = 48Kbps(1)
3 = 48Kbps(2)
1
03
Originating Point Code Assign the Point Code of own side.
0~16367
0
04
Destination Point Code
(T1)
Assign the Point Code of
destination side on the DTI link.
0~16367
0
05
Calling Name Indication
(T1)
Calling name indication is not sent
to destination party if switch is set
to Disable.
0 = Disable
1 = Enable
1
06
Channel Number on the
CCH package
Assignment
0: No setting
1: Channel number on the CCH
Package
0-4
0