NEC Univerge SV8100 - 47-02: VM8000 Inmail Station Mailbox Options

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 563
Description
Use 47-02: VM8000 InMail Station Mailbox Options to set up a station/extension
mailbox. Station mailboxes are automatically assigned as Subscriber Mailboxes.
Normally, VM8000 InMail Station Mailbox numbers 1~26 should correspond to
extensions 200~225 (OT) / 101-126 (AU).

Station Mailboxes are one of three mailbox categories: Station, Routing, or
Master. You can also set up Master Mailboxes as Subscriber Mailboxes.
Program 47 : InMail
47-02: VM8000 InMail Station Mailbox Options
Level:
IN
Input Data
Station Mailbox Number 1~512
Input Data
Item
No.
Item Input Data Default
01
Mailbox Type
Use this option to enable or disable the mailbox. An
extension mailbox is not accessible when it is
disabled (even though its stored messages and
configuration are retained in memory.) If disabled, a
user pressing Message initiates a remote logon and
is asked to enter their mailbox number. A voice
prompt then announces: “That mailbox does not
exist.”
To make programming easier, consider associating
a mailbox number with a station port. For example,
mailbox 1 could correspond to port 1, which in turn
corresponds to extension 200 (OT) / 101 (AU).
0 = None
1 = Personal
2 = Group
1
02
Mailbox Number
Use this option to select the extension number
associated with the mailbox you are programming.
Normally, mailbox 1 should use Mailbox Number 200
(OT) / 101 (AU), mailbox 2 should use Mailbox
Number 201,101 etc.
To make programming easier, consider associating
a mailbox number with a station port. For example,
mailbox 1 could correspond to port 1, which in turn
corresponds to extension 200 (OT) / 101 (AU).
Digits (eight
maximum, using
0~9)
(OT)
Mailbox 1 = 200
Mailbox 2~64 =
201-263
(AU)
Mailbox 1 = 101
Mailbox2~64 =
102-164
(OT/AT)
Mailboxes 65~512
= No entry