NEC Univerge SV8100 - 44-02: Dial Analysis Table for ARS;F-Route Access

Issue 10.1 UNIVERGE SV8100
2 - 532 Program 44 : ARS/F-Route Setup
Description
Use Program 44-02: Dial Analysis Table for ARS/F-Route Access to set the
Pre-Transaction Table for selecting ARS/F-Route.
Program 44 : ARS/F-Route Setup
44-02: Dial Analysis Table for ARS/F-Route Access
Level:
IN
Input Data
Dial Analysis Table Number 1~120
Item
No.
Item Input Data Default
01
Dial
Set the number of digits to be analyzed by the
system for ARS routing.
Up to eight digits
(Use line key 1 for a Don’t
Care digit, @)
No
Setting
02
Service Type
 Service Type 1 (Extension Number)
The number goes to an extension after
deleting the front digit(s).
Additional Data
Assign the digit(s) to be deleted on top of the
number for extension number usage. At least
one digit must be deleted.
 Service Type 2 (ARS/F-Route)
The number is controlled by ARS/F-Route
table.
Additional Data:
If the ARS/F-Route Time Schedule is not
used, assign the ARS/F-Route table number
for Program 44-05.
If the ARS/F-Route Time Schedule is used,
assign the ARS/F-Route selection number for
Program 44-04.
 Service Type 3 (Dial Extension Analyze Table)
The total length of the number exceeds more
than 8 digits.
Additional Data:
Assign the Dial Extension Analysis Table
number to be used in Program 44-03.
0 = No setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Analyze
Table (Option)
0