NEC Univerge SV8100 - Page 569

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 533
Conditions
None
Feature Cross Reference
 Automatic Route Selection (ARS)
03
Additional Data
For the Service Type selected in 44-02-02, enter
the additional data required.
 1: Delete Digit = 0~255
(255 = Delete All Digits)
 2: [Program 44-01: 0]
ARS/F-Route Table Number = 0~500
(0 = No Setting)
Refer to Program 44-05.
[Program 44-01: 1]
ARS/F-Route Select Table Number = 0~500
(0 = No Setting)
Refer to Program 44-04.
 3: Dial Extension Analyze Table Number =
0~4 (0 = No Setting)
Refer to Program 44-03.
1 = Delete Digit = 0~255
(255: Delete All Digits)
2 = 0~500
(0 = No Setting)
3 = Dial Extension Analyze
Table Number = 0~4
(0 = No Setting)
0
04
Dial Tone Simulation
If enabled, this option sends dial tone to the calling
party after the routing is determined. This may be
required if the central office at the destination does
not send dial tone.
0=Off
1=On
0
Item
No.
Item Input Data Default