NEC Univerge SV8100 - Netlink Communication Port Settings

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 653
Description
Use Program 51-09 : NetLink Communication Port Settings to set the various
communication ports used on the system.
Program 51 : NetLink Service
51-09 : NetLink Communication Port Settings
Level:
IN
Input Data
Item
No.
Item Input Data Default
01
Primary Waiting Port
Sets the communication port that the Primary system
uses to communicate with the Secondary system.
0~65535
58000
02
Communication Waiting Port
Port used to communicate between nodes. It is always
opened by all nodes.
0~65535
58001
03
Secondary Communication Port
Secondary system communicates with Primary system at
this port number. If 0 is specified, temporary port is
selected by dynamic.
0~65535
0
04
Primary Search Port
When Fail-Over occurred, each system communicates
with other system at this port number.
If 0 is set, temporary port is selected by dynamic.
If 0 is not specified, the number and continuous maximum
50 number is used.
(Ex. 5000 is specified 5001, 5002…5049 will be used).
0~65535
0
05
Primary Detection Port
Enter port number to seek the Top Priority Primary
system.
If 0 is specified, temporary port is selected by dynamic.
0~65535
0
06
Database Replication Communication Listening
Port
This port is used to replicate database.
0~65535
58002
07
Database Replication Primary Detection Port
This port is used to replicate database.
If 0 is specified, temporary port is selected by dynamic.
0~65535
0