NEC Univerge SV8100 - Program 22: Incoming Call Setup; 22-01: System Options for Incoming Calls

Programming Manual 2 - 341
Program
22
Description
Use Program 22-01: System Options for Incoming Calls to define the
system options for incoming calls.
Program 22 : Incoming Call Setup
22-01: System Options for Incoming Calls
Level:
IN
Input Data
Item
No.
Item Input Data Default Description
Related
Program
01
Incoming Call
Priority
0 = Intercom
Call
Priority
1 = Trunk Call
Priority
1
Use this option to determine if Intercom
calls or trunk calls have answer priority
when both are ringing simultaneously.
15-02-22
02
Incoming Call
Ring No Answer
Alarm
0=Disable
(Off)
1=Enable
(On)
0
If enabled, an incoming call that rings
longer than the Ring No Answer Alarm
interval (22-01-03), changes to a
unique ring cadence to indicate that the
call has been ringing too long. If
disabled, this does not occur.
22-01-03
22-01-04
03
Ring No Answer
Alarm Time
0~64800 (sec)
60
If a trunk rings a multiline telephone
longer than this interval, the system
changes the ring cadence. This
indicates to the user that the call has
been ringing too long.
22-01-02
04
DIL No Answer
Recall Time
0~64800 (sec)
0
A DIL that rings its programmed
destination longer than this interval
diverts to the DIL No Answer Ring
Group (set in Program 22-08).
06
DID Ring-
No-Answer Time
0~64800 (sec)
20
In systems with DID Ring-No-Answer
Intercept, this sets the Ring-No-Answer
time. This time is how long a DID call
rings the destination extension before
rerouting to the intercept ring group.
22-12
07
DID Incoming
Ring Group No
Answer Time
0~64800 (sec)
20
08
DID Pilot Call No
Answer Time
0~64800 (sec)
60