UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 103
Description
Use Program 11-09: Trunk Access Code to assign the trunk access code. The trunk
access code can be set from 1~8 digits which is defined to type 3 and 4 in Program
11-01. This is the code extension users dial to access Automatic Route Selection. The
Individual Trunk Access Code is used when Trunk Group Routing is desired for an
outgoing line.
Program 11 : System Numbering
11-09 : Trunk Access Code
Level:
IN
Caution!
The digit 9 is defined in Program 11-01 as Dial Type() with the Number of Digits
Required set to (). If you change the trunk access code in Program 11-09, you
must make the corresponding changes in Program 11-01.
Input Data
Item
No.
Trunk Access
Code
Description Default Related Program
01
Dial
(Up to four digits)
Use this program to
assign the trunk access
code (normally 9). This is
the code extension users
dial to access Automatic
Route Selection.
9 (OT)
0 (AU)
11-01 : System
Numbering
14-01 ~ 07: Basic
Trunk Data Setup
14-05 : Trunk Group
14-06: Trunk Group
Routing
21-02: Trunk Group
Routing for
Extensions
To Next Page
Loading...
