UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 89
Default
See the following tables for default settings.
9
Dial Extension Analyze
11-20: Dial Extension Analyse Table
Changing the Dial Type for a range of codes can have a dramatic affect on how your system operates.
Assume, for example, the site is a hotel that has room numbers from 100-399. To make extension
numbers correspond to room numbers, you should use Program 11-02 to reassign extension numbers on
each floor from 100 to 399. (Other applications might also require you to change entries in Program
11-10 ~ 11-16.)
Table 2-3 System Numbering Default Settings
Dial Types: 1=Service Code, 2=Extension Number, 3=Trunk Access, 4=Special
Trunk Access, 5=Operator Access, 6=Flexible Routing, 8 = Networking System
Access (OT), 9 = Dial Extension Analyze, 0=Not Used
Dialed Number of Digits Required
Dial Type Networking
ID
[if type 8] - 0-
50
Default New
Default New
1X 3 2
11 0 0
12 0 0
13 0 0
14 0 0
15 0 0
16 0 0
17 0 0
18 0 0
19 0 0
10 0 0
1
00
1
# 00
2X 3 2
21 0 0
22 0 0
23 0 0
24 0 0
25 0 0
26 0 0
Dial
Types
Dial Type Description Related Program
To Next Page
Loading...
