Issue 10.1 UNIVERGE SV8100
1 - 6 Introduction
SECTION 7 USING SOFTKEYS FOR PROGRAMMING
Each UNIVERGE SV8100 display telephone provides interactive Softkeys for intuitive
feature access. The options for these keys will automatically change depending on
where you are in the system programming. Simply press the Softkey located below
the option you wish and the display will change accordingly.
Pressing the VOLUME or VOLUME will scroll between the menus.
Enter characters:
+ , - . / : ; < = > ? B E S ¢ £
#
# = Accepts an entry (only required if two letters on the same
key are needed – ex: TOM). Pressing # again = Space. (In
system programming mode, use the right arrow Softkey
instead to accept and/or add a space.)
Recall
Clear the character entry one character at a time.
Hold
Clear all the entries from the point of the flashing cursor and to
the right.
Table 1-2 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
_
Program Mode
Base Service OP1 OP2
_
Program Mode
CCIS Hard Mtnance
To Next Page
Loading...
