NEC Univerge SV8100 - Page 475

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 439
Default
Item 01 : Internal Paging Group Name
##
= Accepts an entry (only required if two letters on the same key
are needed - ex: TOM). Pressing
# again = Space. (In system
programming mode, use the right arrow soft key instead to accept
and/or add a space.)
Recall Clear the character entry one character at a time.
Hold Clear all the entries from the point of the flashing cursor and to the
right.
Input Data
Internal Paging Group Number 01~64
Item
No.
Item Input Data Default
01
Internal Paging Group Name
Assign name to Internal Paging Groups (i.e., Page
Zones). The system shows the name you program on the
telephone display.
Up to 12 Characters
Refer to
default
table.
02
Internal Paging Splash tone type
Allow an extension to have normal (0), muted (1) or no (2)
Internal Paging alert beeps before a Paging
announcement.
0 = Ordinary volume
1 = Mute
2 = No tone
0
Extension Paging Group Name
01 Group 1
02 Group 2
::
64 Group 64
Key for Entering Names
When entering names in the procedures below, refer to this chart. Names can have up to
12 digits.
Use this keypad
digit . . .
When you want to. . .