NEC Univerge SV8100 - Page 584

Issue 10.1 UNIVERGE SV8100
2 - 548 Program 45 : Voice Mail Integration
05
Message Wait
Enable/disable the system ability to
process the Voice Mail Message Wait
(
#) commands. You should normally
enable this option. If enabled, be sure
that the programmed Message
Notification strings don’t contain the
code for trunk access.
0 = Off
1 = On
1 45-01-13
06
Record Alert Tone Interval Time
This time sets the interval between
Voice Mail Conversation Record alerts
0~64800 (sec)
30 (OT)
0 (AU)
07
Centralized Voice Mail Pilot Number
This number is the same as the
extension number or pilot number.
Dial (up to eight
digits)
No
Setting
08
Centralized Voice Mail Department
Group Number
Assigns which Extension (Department)
Group Number is used as the
Centralized Voice Mail group.
0~64
0
09
Centralized Voice Mail Master Name
Assigns the Centralized Voice Mail
Master Name.
Up to 12
characters
“C.V.M.”
10
New NSL Protocol support
0 = Off
1 = On
0
11
Prefix for Call Screening
Dial (One digit)
1 45-01-03
12
Prefix for Park and Page
Dial (One digit)
 45-01-04
13
Prefix for Message Wait
Dial (One digit)
# 45-01-05
14
CCIS Centralized Voice Mail Number
Assign the pilot number to Centralized
Voice Mail over CCIS Link. This is
assigned only in the remote switches.
Dial (up to eight
digits)
No
Setting
15
Analog Voice Mail Protocol Selection
Assigns whether fixed codes are used
or the codes used in PRG 45-04 are
used for analog voice mail protocol.
0: Fixed
1: Program
0 45-04
11-11-
50/51
16
Voice Mail Fax Digit Add Assignment
Assign up to four digits in front of the
station number sent to the SLT port
when a call is forwarded.
Up to four digits
None 15-03-16
Input Data (Continued)
Item
No.
Item Input Data Default
Related
PRG