NEC Univerge SV8100 - Page 684

Issue 10.1 UNIVERGE SV8100
2 - 648 Program 51 : NetLink Service
Description
Use Program 51-05: NetLink Timer Settings to set the various timers within the
NetLink system.
Program 51 : NetLink Service
51-05 : NetLink Timer Settings
Level:
IN
Item
No.
Item Input Data Default
01
Keep Alive Sending Interval
This is the Keep Alive timer sending time from the
Secondary system to confirm communication with the
Primary system.
1~3600
5
02
Keep Alive Response Waiting Time
This is the time interval the Secondary system waits for a
response from the Primary system before cutting off
communication.
0, 5~10800
(0 = infinity)
0
03
Primary Search Packet Sending Interval
While searching the Primary system, the system sends a
packet at this interval.
1~3600
5
04
Primary Search Time Maximum Value
Total time of Primary system seek time.
5~10800
20
05
Top Priority Primary Detection Packet Sending
Interval
When current Primary system is not Top Priority Primary
System, the system sends packet to check if Top Priority
System exists.
1~3600
10
06
Primary Compulsion Specification Trial Maximum
Time
When the forced change Primary command is executed,
the system will search the new Primary system for this
amount of time.
1~10800
30
07
Socket Refresh Time
For some reason, the IP connection may become
unstable. Then keep-alive function does not work. To
avoid this, if there is no data traffic for this time, the socket
is refreshed.
20~3600
40