NEC Univerge SV8100 - Page 815

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 779
11
G.729 Jitter Buffer - Maximum
Set the maximum G.729 Jitter Buffer.
Moreover, this option is adjusted with the
SV8100 as it is used by both IP terminals and
the IPLA and the range of the adjustment of
Jitter for the IP terminal is narrower and
transmitted to the IP terminal. The range of IP
terminal is 10-300 (10).
0~300ms (Note 1)
120
12
Number of G.723 Audio Frame
Maximum number of the G.723 Audio Frame
(corresponds to 5.3kbps ACELP method).
1 = 30 msec
2 = 60 msec
1
13
G.723 Silence Compression (VAD) Mode
If enabled, RTP packets are not sent for the
compressed silence.
Not used by IPLB.
0 = Disable
1=Enable
0
14
G.723 Jitter Buffer - Minimum
Set the minimum value of the G.723 Jitter
Buffer.
Moreover, this option is adjusted with the
SV8100 as it is used by both IP terminals and
the IPLA and the range of the adjustment of
Jitter for the IP terminal is narrower and
transmitted to the IP terminal. The range of IP
terminal is 10-300 (10).
0~300ms (Note 1)
30
15
G.723 Jitter Buffer - Standard
Set the average value of the G.723 Jitter
Buffer.
Moreover, this option is adjusted with the
SV8100 as it is used by both IP terminals and
the IPLA and the range of the adjustment of
Jitter for the IP terminal is narrower and
transmitted to the IP terminal. The range of IP
terminal is 10-300 (10).
0~300ms (Note 1)
60
16
G.723 Jitter Buffer - Maximum
Set the maximum value of the G.723 Jitter
Buffer.
Moreover, this option is adjusted with the
SV8100 as it is used by both IP terminals and
the IPLA and the range of the adjustment of
Jitter for the IP terminal is narrower and
transmitted to the IP terminal. The range of IP
terminal is 10-300 (10).
0~300ms (Note 1)
120
Item
No.
Item Input Data Default