NEC Univerge SV8100 - Page 833

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 797
13
E.164 Incoming/Outgoing via SIP
Trunk URI
When making an incoming or
outgoing call via SIP trunk, enable
or disable conversion of SIP-URI to
from E.164 format (E.g.
+850XXXX) for PSTN. When
making an outgoing call at SIP
trunk, add ‘+’ and International
Access Code set in PRG 10-02-02
to SIP-URI. When making an
incoming call at SIP trunk, delete ‘+’
and International Access Code
when matching PRG 10-02-02 to
SIP-URI.
0 = Off
1 = Mode 1
2 = Mode 2
3 = Mode 3
0
15
100rel Settings
Outbound Call:
When set to 0 the 101rel is included
in the supported header of the
invite message.When set to 1 the
101rel is NOT included in the
supported header of the invite
message
Inbound Call:
When set to 0 and the Invite
includes a 101rel in the supported
header of the invite message the
provisional 1XX (excluding the 100
Trying) Will contain a 100rel in the
supported header (which means
the other side must PRACK
thismessage). When set to 1 and
the Invite includes a 101rel in the
supported header of the invite
message the provisional 1XX
(excluding the 100 Trying) Will NOT
contain a 100rel in the supported
header (which means NO PRACK
required).
0 = Use default settings
1 = Use opposite settings
0
16
SIP Trunk SIP-URI E.164
Incoming Mode
0 = Off
1 = Mode 1
2 = Mode 2
0
17
Call Forward Moved Temporarily
Support
Input Data 1: When enabled a 302
Moved temporarily response is sent
for external call forward
destinations.
0 = Disabled
1 = 302 Return
0
Input Data
Item
No.
Item Input Data Default