NEC Univerge SV8100 - Page 849

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 813
Note 1: For IPLA, 0~270ms is valid. If set to more than 270ms, then buffer size is 270ms.
37
iLBC Audio Frame
Maximum number of iLBC Audio Frames. iLBC
assumes the frame of 10ms is a unit.
2=20 ms
3=30 ms
4=40 ms
3
38
iLBC Silence Compression Mode
Select whether to compress silence with iLBC.
When there is silence, the RTP packet is not
sent.
Not used by IPLB.
0 = Disable
1 = Enable
0
39
iLBC Jitter Buffer - Minimum
Set the minimum value of the Jitter Buffer of iLBC
is set. Jitter is the variation in the time between
packets arriving and the buffer allows this
variation to be absorbed.
0~255ms (Note 2)
30
40
iLBC Jitter Buffer - Standard
Set the average iLBC Jitter Buffer.
0~255ms (Note 2)
60
41
iLBC Jitter Buffer - Maximum
Set the maximum iLBC Jitter Buffer.
0~255ms (Note 2)
120
42
FAX Relay Mode
0 = Disable
1 = Enable
2 = Each Port Mode (each
extension)
0
43
RTP Filter
To avoid incorrect voice pass connection, this
Program checks the sending side address from
received RTP packet at VoIPDB.
0 = Disable
1 = Enable
1
44
DTMF Level Mode
Used only by IPLB.
0 = VoIPU default value
1 = Main soft value
0
45
DTMF Level High
Used only by IPLB.
0 = Disable
1 = -33dBm
:
28 = -6dBm
28
46
DTMF Level Low
Used only by IPLB.
0 = Disable
1 = -33dBm
:
28 = -6dBm
28
47
FAX over IP Type
Type 1: SV8100 original mode.
Type 2: PBX compatible mode.
0 = Type 1
1 = Type 2
0
Input Data
Item
No.
Item Input Data Default