NEC Univerge SV8100 - Page 863

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 827
38
Number of G.726 Audio Frames
1~4
1 = 10ms
2 = 20ms
3 = 30ms
4 = 40ms
3
39
G.726 Voice Activity Detection Mode
0 = Disabled
1 = Enabled
0
40
G.726 Jitter Buffer (min)
0~255ms (Note 2)
30
41
G.726 Jitter Buffer (Average)
0~255ms (Note 2)
60
42
G.726 Jitter Buffer (max)
0~255ms (Note 2)
120
43
iLBC Audio Frame
Maximum number of iLBC Audio Frames.
iLBC assumes the frame of 10ms is a unit.
2 = 20 ms
3 = 30 ms
4 = 40 ms
3
44
iLBC Silence Compression Mode
Select whether to compress silence with
iLBC. When there is silence, the RTP packet
is not sent.
Not used by IPLB.
0 = Disable
1 = Enable
0
45
iLBC Jitter Buffer - Minimum
Set the minimum value of the Jitter Buffer of
iLBC is set. Jitter is the variation in the time
between packets arriving and the buffer
allows this variation to be absorbed.
0~255ms (Note 2)
30
46
iLBC Jitter Buffer - Standard
Set the average iLBC Jitter Buffer.
0~255ms (Note 2)
60
47
iLBC Jitter Buffer - Maximum
Set the maximum iLBC Jitter Buffer.
0~255ms (Note 2)
120
48
ILBC Payload Number
The payload number of iLBC is set. However,
the same number as Item 31 cannot be set.
96-127
98
49
RTP Filter
To avoid incorrect voice pass connection, this
Program checks the sending side address
from received RTP packet at VoIPDB.
0 = Disable
1 = Enable
1
50
DTMF Level Mode
Used only by IPLB.
0 = VoIPU default value
1 = Main soft value
0
Input Data
Item
No.
Item Input Data Default