NEC Univerge SV8100 - Page 913

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 877
Conditions
 The entire terminal that has an Alarm Display setting can be set at PRG90-50-01.
 System Alarm Type is shown despite the setting done at 90-10-01. If multiple
Alarm Display Setting is set, only one highest priority alarm will be shown on a
LCD Display.
 The priority level (highest -> lowest): Alarm 55 > Alarm 7 > Alarm 5 > Alarm 30 >
Alarm 8 > Alarm 52> Alarm 29 > Free Demo License Period.
Feature Cross Reference
None
100 1 0 NetLink link
error.
This alarm occurs when
the primary system cannot
communicate with
secondary system
Primary system
cannot
communicate with
Secondary system
because of
Network error
Primary system cannot
communicate with
Secondary system
because of Network
error
WAR
Table 2-20 Description of Alarm (Continued)
Alarm
No.
Type Report Name Content of Alarm Cause Action Recovery
Alarm
Status