Switching Commands
116
ProSafe Managed Switch
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value and disables
unicast storm recovery for all interfaces.
Format no storm-control unicast level
Mode
storm-control unicast rate (Global)
Use this command to configure the unicast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, unicast storm recovery is active, and if the rate of
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the
traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured threshold.
Default
Format storm-control unicast rate <0-14880000>
Mode
no storm-control unicast rate
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery.
Format no storm-control unicast rate
Mode
storm-control flowcontrol
This command enables 802.3x flow control for the switch and only applies to full-duplex
mode ports.
Note: 802.3x flow control works by pausing a port when the port becomes
oversubscribed and dropping all traffic for small bursts of time during
the congestion condition. This can lead to high-priority and/or
network control traffic loss.
Global Config
0
Global Config
Global Config
Default
disabled
Format storm-control flowcontrol
Mode
Global Config
To Next Page
Loading...
