NETGEAR ProSafe GSM7224P - Clear Dot1 X Authentication-History; Dot1 X Dynamic-Vlan Enable; Dot1 X System-Auth-Control Monitor

Switching Commands
98
ProSafe Managed Switch
clear dot1x authentication-history
This command clears the authentication history table captured during successful and
unsuccessful authentication on all interface or the specified interface.
Format clear dot1x authentication-history [unit/slot/port]
Mode
dot1x dynamic-vlan enable
Use this command to enable the switch to create VLANs dynamically when a RADIUS
assigned VLAN does not exist in the switch.
Format dot1x dynamic-vlan enable
Mode
Default
no dot1x dynamic-vlan enable
Use this command to disable the switch from creating VLANs dynamically when a RADIUS
assigned VLAN does not exist in the switch.
Format no dot1x dynamic-vlan enable
Mode
dot1x system-auth-control monitor
Use this command to enable the 802.1X monitor mode on the switch. The purpose of Monitor
mode is to help troubleshoot port-based authentication configuration issues without
disrupting network access for hosts connected to the switch. In Monitor mode, a host is
granted network access to an 802.1X-enabled port even if it fails the authentication process.
The results of the process are logged for diagnostic purposes.
Format dot1x system-auth-control monitor
Mode
Default
no dot1x system-auth-control monitor
Use this command to disable the 802.1X monitor on the switch.
Format no dot1x system-auth-control monitor
Mode
Global Config
Global Config
Disabled
Global Config
Global Config
Disabled
Global Config