NETGEAR ProSafe GSM7224P - ICMP Throttling Commands; Ip Unreachables; Ip Redirects

Routing Commands
316
ProSafe Managed Switch
ICMP Throttling Commands
This section describes the commands you use to configure options for the transmission of
various types of ICMP messages.
ip unreachables
Use this command to enable the generation of ICMP Destination Unreachable messages. By
default, the generation of ICMP Destination Unreachable messages is enabled.
Default
Format ip unreachables
Mode
no ip unreachables
Use this command to prevent the generation of ICMP Destination Unreachable messages.
Format no ip unreachables
Mode
ip redirects
Use this command to enable the generation of ICMP Redirect messages by the router. By
default, the generation of ICMP Redirect messages is disabled.
Default
Format ip redirects
Mode
• Global Config
• Interface Config
no ip redirects
Use this command to prevent the generation of ICMP Redirect messages by the router.
Format no ip redirects
Mode
• Global Config
• Interface Config
Bad Routes
Received
The number of routes contained in valid RIP packets that were ignored for any reason.
Updates Sent
The number of triggered RIP updates actually sent on this interface.
enable
Interface Config
Interface Config
disabled
Term Definition