NETGEAR ProSafe GSM7224P - Non-Stop Forwarding Commands

Stacking Commands
30
ProSafe Managed Switch
show stack-port diag
This command shows front panel stacking diagnostics for each port and is only intended for
Field Application Engineers (FAEs) and developers. An FAE will advise on the necessity to
run this command and capture this information.
Format show stack-port diag
Mode
Non-Stop Forwarding Commands
Non-stop forwarding allows the stack units to continue to forward packets if the stack
management unit restarts because of a power failure, hardware failure, or software fault.
nsf
Use this command to enable nonstop forwarding feature on the stack. When nonstop
forwarding is enabled, if the management unit of a stack fails, the backup unit takes over as
the master without clearing the hardware tables of any of the surviving units. Data traffic
Term Definition
Unit
The unit number.
Interface
The slot and port numbers.
Tx Data Rate
Trashing data rate in megabits per second on the stacking port.
Tx Error Rate
Platform-specific number of transmit errors per second.
Tx Total Error
Platform-specific number of total transmit errors since power-up.
Rx Data Rate
Receive data rate in megabits per second on the stacking port.
Rx Error Rate
Platform-specific number of receive errors per second.
Rx Total Errors
Platform-specific number of total receive errors since power-up.
Privileged EXEC
Term Definition
Unit
The unit number.
Interface
The slot and port numbers.
Diagnostic Entry1
80 character string used for diagnostics.
Diagnostic Entry2
80 character string used for diagnostics.
Diagnostic Entry3
80 character string used for diagnostics.