NETGEAR ProSafe GSM7224P - Logging Host Remove; Logging Syslog; Show Logging

Utility Commands
518
ProSafe Managed Switch
logging host remove
This command disables logging to host. See show logging hosts on page 519 for a list of host
indexes.
Format logging host remove <hostindex>
Mode
logging syslog
This command enables syslog logging. The <portid> parameter is an integer with a range
of 1-65535.
Default
Format logging syslog [port <portid>]
Mode
no logging syslog
This command disables syslog logging.
Format no logging syslog
Mode
show logging
This command displays logging configuration information.
Format show logging
Mode
Global Config
disabled
Global Config
Global Config
Privileged EXEC
Term Definition
Logging Client
Local Port
Port on the collector/relay to which syslog messages are sent.
CLI Command
Logging
Shows whether CLI Command logging is enabled.
Console
Logging
Shows whether console logging is enabled.
Console
Logging
Severity Filter
The minimum severity to log to the console log. Messages with an equal or lower
numerical severity are logged.
Buffered
Logging
Shows whether buffered logging is enabled.
Syslog Logging
Shows whether syslog logging is enabled.