EasyManua.ls Logo

NETGEAR ProSafe GSM7224P - Show Interface

NETGEAR ProSafe GSM7224P
740 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Utility Commands
508
ProSafe Managed Switch
show interface
This command displays a summary of statistics for a specific interface or a count of all CPU
traffic based upon the argument.
Format show interface {<unit/slot/port> | switchport}
Mode
The display parameters, when the argument is <unit/slot/port>, are as follows:
Packets
Received
Without Error
Packets
Received With
Error
Broadcast
Packets
Received
Packets
Transmitted
Without Error
Transmit
Packets Errors
Collisions
Frames
Time Since
Counters Last
Cleared
The display parameters, when the argument is “switchport” are as follows:
Privileged EXEC
Parameters Definition
The total number of packets (including broadcast packets and multicast packets)
received by the processor.
The number of inbound packets that contained errors preventing them from being
deliverable to a higher-layer protocol.
The total number of packets received that were directed to the broadcast address. Note
that this does not include multicast packets.
The total number of packets transmitted out of the interface.
The number of outbound packets that could not be transmitted because of errors.
The best estimate of the total number of collisions on this Ethernet segment.
The elapsed time, in days, hours, minutes, and seconds since the statistics for this port
were last cleared.
Term Definition
Packets
Received
Without Error
The total number of packets (including broadcast packets and multicast packets)
received by the processor.
Broadcast
Packets
Received
The total number of packets received that were directed to the broadcast address. Note
that this does not include multicast packets.
Packets
Received With
Error
The number of inbound packets that contained errors preventing them from being
deliverable to a higher-layer protocol.
Packets
Transmitted
Without Error
The total number of packets transmitted out of the interface.
Broadcast
Packets
Transmitted
The total number of packets that higher-level protocols requested to be transmitted to the
Broadcast address, including those that were discarded or not sent.

Table of Contents

Related product manuals