Routing Commands
269
ProSafe Managed Switch
enable (OSPF)
This command resets the default administrative mode of OSPF in the router (active).
Default
Format enable
Mode
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
Format no enable
Mode
network area (OSPF)
Use this command to enable OSPFv2 on an interface and set its area ID if the IP address of
an interface is covered by this network command.
Default
Format network <ip-address> <wildcard-mask> area <area-id>
Mode
no network area (OSPF)
Use this command to disable the OSPFv2 on a interface if the IP address of an interface was
earlier covered by this network command.
Format no network <ip-address> <wildcard-mask> area <area-id>
Mode
ip ospf area
Use this command to enable OSPFv2 and set the area ID of an interface. The <area-id> is
an IP address formatted as a 4-digit dotted-decimal number or a decimal value in the range
of <0-4294967295>. This command supersedes the effects of the network area
command. It can also be used to configure the advertiseability of the secondary addresses
on this interface into the OSPFv2 domain.
Default
Format ip ospf area <area-id> [secondaries none]
Mode
enabled
Router OSPF Config
Router OSPF Config
disabled
Router OSPF Config
Router OSPF Config
disabled
Interface Config
To Next Page
Loading...
