NETGEAR ProSafe GSM7224P - Show Ip Vrrp; Show Ip Vrrp Interface

Routing Commands
261
ProSafe Managed Switch
show ip vrrp
This command displays whether VRRP functionality is enabled or disabled on the switch. It
also displays some global parameters which are required for monitoring. This command
takes no options.
Format show ip vrrp
Modes
• Privileged EXEC
• User EXEC
Admin Mode
Router
Checksum
Errors
Router Version
Errors
Router VRID
Errors
show ip vrrp interface
This command displays all configuration information and VRRP router statistics of a virtual
router configured on a specific interface. Use the output of the command to verify the track
interface and track IP route configurations.
Format show ip vrrp interface {<interface-name> <vrid> }
Modes
• Privileged EXEC
• User EXEC
Authentication
Type Mismatch
The total number of VRRP advertisements received for which 'auth type' not equal to
locally configured one for this virtual router.
Packet Length
Errors
The total number of VRRP packets received with packet length less than length of VRRP
header.
Term Definition
The administrative mode for VRRP functionality on the switch.
The total number of VRRP packets received with an invalid VRRP checksum value.
The total number of VRRP packets received with Unknown or unsupported version
number.
The total number of VRRP packets received with invalid VRID for this virtual router.
Term Definition
Primary IP
Address
The configured IP address for the Virtual router.
VMAC address
The VMAC address of the specified router.
Authentication
type
The authentication type for the specific virtual router.
Priority
The priority value for the specific virtual router, taking into account any priority
decrements for tracked interfaces or routes.
Term Definition