NETGEAR ProSafe GSM7224P - Release Dhcp; Renew Dhcp; Ip Default-Gateway

Routing Commands
239
ProSafe Managed Switch
no ip address dhcp
Use this command to release a leased address and disable DHCPv4 on an interface.
Format no ip address dhcp
Mode
ip default-gateway
Use this command to manually configure a default gateway for the switch. Only one default
gateway can be configured. If you use this command multiple times, each command replaces
the previous value.
Format ip default-gateway <ipaddr>
Mode
no ip default-gateway
Use this command to remove the default gateway address from the configuration.
Format no ip default-gateway <ipaddr>
Mode
release dhcp
Use this command to force the DHCPv4 client to release the leased address from the
specified interface.
Format release dhcp <unit/slot/port>
Mode
renew dhcp
Use this command to force the DHCPv4 client to immediately renew an IPv4 address lease
on the specified interface.
Format renew dhcp {<unit/slot/port>|network-port}
Mode
Note: This command can be used on in-band ports as well as network
(out-of-band) port.
Interface Config
Global Config
Interface Config
Privileged EXEC
Privileged EXEC