Stacking Commands
27
ProSafe Managed Switch
show switch
This command displays information about all units in the stack or a single unit when you
specify the unit value.
Format show switch [<unit>]
Mode
Switch
When you do not specify a value for <unit>, the following information appears:
Management
Status
Preconfigured
Model Identifier
Plugged-In Model
Identifier
Switch Status
Code Version
When you specify a value for <unit>, the following information appears:
Model Identifier
The model identifier for the supported card type.
Card Description
The description for the supported card type.
Privileged EXEC
Term Definition
The unit identifier assigned to the switch.
Term Definition
Indicates whether the switch is the Primary Management Unit, a stack member, or the
status is unassigned.
The model identifier of a preconfigured switch ready to join the stack. The Model
Identifier is a 32-character field assigned by the device manufacturer to identify the
device.
The model identifier of the switch in the stack. Model Identifier is a 32-character field
assigned by the device manufacturer to identify the device.
The switch status. Possible values for this state are: OK, Unsup ported, Code
Mismatch, Config Mismatch, or Not Present.
The detected version of code on this switch.
Term Definition
Management
Status
Indicates whether the switch is the Primary Management Unit, a stack member, or the
status is unassigned.
Hardware
Management
Preference
The hardware management preference of the switch. The hardware management
preference can be disabled or unassigned.
Admin
Management
Preference
The administrative management preference value assigned to the switch. This
preference value indicates how likely the switch is to be chosen as the Primary
Management Unit.
Switch Type
The 32-bit numeric switch type.
Term Definition
To Next Page
Loading...
Need help?
General