NETGEAR ProSafe GSM7224P - Ipv6 Access-List Rename; Deny | Permit} (Ipv)

Quality of Service (QoS) Commands
482
ProSafe Managed Switch
If an IPv6 ACL by this name already exists, this command enters IPv6-Access-List config
mode to allow updating the existing IPv6 ACL.
Note: The CLI mode changes to IPv6-Access-List Config mode when you
successfully execute this command.
no ipv6 access-list
This command deletes the IPv6 ACL identified by <name> from the system.
Format no ipv6 access-list <name>
Mode
ipv6 access-list rename
This command changes the name of an IPv6 ACL. The <name> parameter is the name of an
existing IPv6 ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1
to 31 characters uniquely identifying the IPv6 access list.
This command fails is an IPv6 ACL by the name <newname> already exists.
Format ipv6 access-list rename <name> <newname>
Mode
{deny | permit} (IPv6)
This command creates a new rule for the current IPv6 access list. Each rule is appended to
the list of configured rules for the list.
Note: The ‘no’ form of this command is not supported, since the rules
within an IPv6 ACL cannot be deleted individually. Rather, the entire
IPv6 ACL must be deleted and respecified.
Note: An implicit ‘deny all’ IPv6 rule always terminates the access list.
Format ipv6 access-list <name>
Mode
Global Config
Global Config
Global Config