NETGEAR ProSafe GSM7224P - Show Ip Ospf Interface

Routing Commands
297
ProSafe Managed Switch
show ip ospf interface
This command displays the information for the IFO object or virtual interface tables.
Format show ip ospf interface {<unit/slot/port> | loopback <loopback-id> |
vlan <1-4093>}
Mode
• Privileged EXEC
• User EXEC
IP Address
Subnet Mask
Secondary IP
Address(es)
OSPF Admin
Mode
OSPF Area ID
OSPF Network
Type
Router Priority
Retransmit
Interval
Hello Interval
Dead Interval
LSA Ack
Interval
Transit Delay
Interval
Authentication
Type
Metric Cost
Passive Status
OSPF
MTU-ignore
Subtotal
Number of entries for the identified area.
Opaque AS
Number of opaque AS LSAs in the database.
Total
Number of entries for all areas.
Term Definition
The IP address for the specified interface.
A mask of the network and host portion of the IP address for the OSPF interface.
The secondary IP addresses if any are configured on the interface.
States whether OSPF is enabled or disabled on a router interface.
The OSPF Area ID for the specified interface.
The type of network on this interface that the OSPF is running on.
A number representing the OSPF Priority for the specified interface.
A number representing the OSPF Retransmit Interval for the specified interface.
A number representing the OSPF Hello Interval for the specified interface.
A number representing the OSPF Dead Interval for the specified interface.
A number representing the OSPF LSA Acknowledgment Interval for the specified
interface.
A number representing the OSPF Transit Delay for the specified interface.
The OSPF Authentication Type for the specified interface are: none, simple, and encrypt.
The cost of the OSPF interface.
Shows whether the interface is passive or not.
Indicates whether to ignore MTU mismatches in database descriptor packets sent from
neighboring routers.
Term Definition