Switching Commands
185
ProSafe Managed Switch
For each interface, or for the interface you specify, the following information appears:
Admin Mode
Dynamic Limit
Static Limit
Violation Trap
Mode
show port-security dynamic
This command displays the dynamically locked MAC addresses for the port.
Format show port-security dynamic <unit/slot/port>
Mode
MAC Address
show port-security static
This command displays the statically locked MAC addresses for port.
Format show port-security static <unit/slot/port>
Mode
MAC Address
show port-security violation
This command displays the source MAC address of the last packet discarded on a locked
port.
Format show port-security violation <unit/slot/port>
Mode
MAC Address
Term Definition
Port Locking mode for the Interface.
Maximum dynamically allocated MAC Addresses.
Maximum statically allocated MAC Addresses.
Whether violation traps are enabled.
Privileged EXEC
Term Definition
MAC Address of dynamically locked MAC.
Privileged EXEC
Term Definition
MAC Address of statically locked MAC.
Privileged EXEC
Term Definition
MAC Address of discarded packet on locked port.
To Next Page
Loading...
Need help?
General