NETGEAR ProSafe GSM7224P - Show Ip Ospf Database

Type
Router ID
Cost
Area ID
Next Hop
Next Hop Intf
Routing Commands
295
ProSafe Managed Switch
show ip ospf database
This command displays information about the link state database when OSPF is enabled. If
you do not enter any parameters, the command displays the LSA headers for all areas. Use
the optional <areaid> parameter to display database information about a specific area. Use
the optional parameters to specify the type of link state advertisements to display.
asbr-summary
external
network
nssa-external
opaque-area
opaque-as
opaque-link
router
summary
adv-router
self-originate
Term Definition
The type of the route to the destination. It can be one of the following values:
intra — Intra-area route
inter — Inter-area route
Router ID of the destination.
Cost of using this route.
The area ID of the area from which this route is learned.
Next hop toward the destination.
The outgoing router interface to use when forwarding traffic to the next hop.
Parameter Description
Use asbr-summary to show the autonomous system boundary router (ASBR) summary
LSAs.
Use external to display the external LSAs.
Use network to display the network LSAs.
Use nssa-external to display NSSA external LSAs.
Use opaque-area to display area opaque LSAs.
Use opaque-as to display AS opaque LSAs.
Use opaque-link to display link opaque LSAs.
Use router to display router LSAs.
Use summary to show the LSA database summary information.
Use adv-router to show the LSAs that are restricted by the advertising router.
Use self-originate to display the LSAs in that are self originated. The information
below is only displayed if OSPF is enabled