NETGEAR ProSafe GSM7224P - Router Discovery Protocol Commands; Show Ip Stats; Ip Irdp; Ip Irdp Multicast

Routing Commands
250
ProSafe Managed Switch
show ip stats
This command displays IP statistical information. Refer to RFC 1213 for more information
about the fields that are displayed.
Format show ip stats
Modes
• Privileged EXEC
• User EXEC
Router Discovery Protocol Commands
This section describes the commands you use to view and configure Router Discovery
Protocol settings on the switch. The Router Discovery Protocol enables a host to discover the
IP address of routers on the subnet.
ip irdp
This command enables Router Discovery on an interface.
Default
Format ip irdp
Mode
no ip irdp
This command disables Router Discovery on an interface.
Format no ip irdp
Mode
ip irdp multicast
This command configures the address that the interface uses to send the router discovery
advertisements. The address is 224.0.0.1, which is the all-hosts IP multicast address.
Default
Format ip irdp multicast
Mode
disabled
Interface Config
Interface Config
224.0.0.1
Interface Config