NETGEAR ProSafe GSM7224P - Redistribute (Rip)

Routing Commands
313
ProSafe Managed Switch
no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
Format no hostroutesaccept
Mode
split-horizon
This command sets the RIP split horizon mode. Split horizon is a technique for avoiding
problems caused by including routes in updates sent to the router from which the route was
originally learned. The options are: None - no special processing for this case. Simple - a
route will not be included in updates sent to the router from which it was learned. Poisoned
reverse - a route will be included in updates sent to the router from which it was learned, but
the metric will be set to infinity.
Default
Format split-horizon {none | simple | poison}
Mode
no split-horizon
This command sets the default RIP split horizon mode.
Format no split-horizon
Mode
redistribute (RIP)
This command configures RIP protocol to redistribute routes from the specified source
protocol/routers. There are five possible match options. When you submit the command
redistribute ospf match <match-type> the match-type or types specified are added to any
match types presently being redistributed. Internal routes are redistributed by default.
Default
• metric—not-configured
• match—internal
Format for
OSPF as
source
protocol
redistribute ospf [metric <0-15>] [match [internal] [external 1]
[external 2] [nssa-external 1] [nssa-external-2]]
Format for
other source
protocol
redistribute {static | connected} [metric <0-15>]
Mode
Router RIP Config
simple
Router RIP Config
Router RIP Config
Router RIP Config