NETGEAR ProSafe GSM7224P - Serviceability Packet Tracing Commands

Utility Commands
561
ProSafe Managed Switch
no capture all packets
This command disables the capturing of all packets.
Format no capture all packets
Mode
capture wrap
This command enables the Buffer Wrapping configuration. Once the capture buffer is full,
writes to the buffer will wrap around to allow continuous packet capture.
Format capture wrap
Mode
Default
show capture packets
This command displays packets being captured from the buffer. The output of the show
command can be redirected to a text file. The resultant text file can be fed to the text2pcap
utility or the Ethereal public domain packet analyzer, which can then be translated to a cap
file.
Format show capture packets
Mode
Default
Serviceability Packet Tracing Commands
These commands improve the capability of network engineers to diagnose conditions
affecting their managed switch product.
CAUTION:
The output of the debug commands can be long and may adversely affect
system performance.
debug arp
Use this command to enable ARP debug protocol messages.
Global Config
Global Config
Enabled
Global Config
Enabled
Default
disabled