NETGEAR ProSafe GSM7224P - Lldp Notification; Lldp Transmit-Mgmt; Lldp Notification-Interval

Switching Commands
188
ProSafe Managed Switch
lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs.
Default
Format lldp transmit-mgmt
Mode
no lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs. Use this command to cancel inclusion of the management
information in LLDPDUs.
Format no lldp transmit-mgmt
Mode
lldp notification
Use this command to enable remote data change notifications.
Default
Format lldp notification
Mode
no lldp notification
Use this command to disable notifications.
Default
Format no lldp notification
Mode
lldp notification-interval
Use this command to configure how frequently the system sends remote data change
notifications. The <interval> parameter is the number of seconds to wait between sending
notifications. The valid interval range is 5-3600 seconds.
Default
Format lldp notification-interval <interval>
Mode
enabled
Interface Config
Interface Config
disabled
Interface Config
disabled
Interface Config
5
Global Config