Management Commands
621
ProSafe Managed Switch
passwords strength minimum special-characters
Use this command to enforce a minimum number of special characters that a password
should contain. The valid range is 0-16. The default is 2. Minimum of 0 means no restriction
on that set of characters.
Format passwords strength minimum special-letters
Mode
Default
no passwords strength minimum special-letters
Use this command to reset the minimum number of special letters to the default value.
Format no passwords strength minimum special-letters
Mode
passwords strength maximum consecutive-characters
Use this command to enforce a maximum number of consecutive characters that a password
should contain. An example of consecutive characters is abcd. The valid range is 0-16. If a
password has consecutive characters more than the configured limit, it fails to configure. The
default is 0. A maximum of 0 means no restriction on that set of characters.
Format passwords strength maximum consecutive-characters
Mode
Default
no passwords strength maximum consecutive-characters
Use this command to reset the maximum number of consecutive characters to the default
value.
Format no passwords strength maximum consecutive-characters
Mode
passwords strength maximum repeated-characters
Use this command to enforce a maximum number of repeated characters that a password
should contain. An example of repeated characters is aaaa. The valid range is 0-16. If a
password has a repetition of characters more than the configured limit, it fails to configure.
The default is 0. A maximum of 0 means no restriction on that set of characters.
Global Config
2
Global Config
Global Config
0
Global Config
Format passwords strength maximum repeated-characters
To Next Page
Loading...
