Switching Commands
55
ProSafe Managed Switch
no spanning-tree port mode
This command sets the Administrative Switch Port State for this port to disabled.
Format no spanning-tree port mode
Mode
spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to enabled.
Default
Format spanning-tree port mode all
Mode
no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
Format no spanning-tree port mode all
Mode
spanning-tree edgeport all
This command specifies that every port is an Edge Port within the common and internal
spanning tree. This allows all ports to transition to Forwarding State without delay.
Format spanning-tree edgeport all
Mode
no spanning-tree edgeport all
This command disables Edge Port mode for all ports within the common and internal
spanning tree.
Format no spanning-tree edgeport all
Mode
spanning-tree bpduforwarding
Normally a switch will not forward Spanning Tree Protocol (STP) BPDU packets if STP is
disabled. However, if in some network setup, the user wishes to forward BDPU packets
received from other network devices, this command can be used to enable the forwarding.
Interface Config
enabled
Global Config
Global Config
Global Config
Global Config
Default
disabled
To Next Page
Loading...
