IP Multicast Commands
334
ProSafe Managed Switch
no ip pim join-prune-interval
Use this command to set the join/prune interval to the default value.
Format no ip pim join-prune-interval
Mode
ip pim register-rate-limit
This command configures the Register Threshold rate for the Rendezvous Point router to
switch to a source-specific shortest path. The valid values are from (0 to 2000 kilobits/sec).
Default
Format ip pim register-rate-limit <0-2000>
Mode
no ip pim register-rate-limit
This command resets the register threshold rate for the Rendezvous Pointer router to the
default value.
Format no ip pim register-rate-limit
Mode
ip pim rp-address
This command is used to statically configure the RP address for one or more multicast
groups. The parameter <rp-address> is the IP address of the RP. The parameter
<groupaddress> is the group address supported by the RP. The parameter <groupmask>
is the group mask for the group address. The optional keyword override indicates that if
there is a conflict, the RP configured with this command prevails over the RP learned by
BSR.
Default
Format ip pim rp-address <rp-address> <group-address> <group-mask>
[override]
Mode
no ip pim rp-address
This command is used to statically remove the RP address for one or more multicast groups.
Format no ip pim rp-address <rp-address> <group-address> <group-mask>
[override]
Mode
Interface Config
0
Global Config
Global Config
disabled
Global Config
Global Config
To Next Page
Loading...
