NETGEAR ProSafe GSM7224P - Debug Lacp Packet; Debug Mldsnooping Packet

Utility Commands
571
ProSafe Managed Switch
no debug ipv6 pimsm packet
Use this command to disable debug tracing of PIMSMv6 packet reception and transmission.
Format no debug ipv6 pimsm packet [receive|transmit]
Mode
debug lacp packet
This command enables tracing of LACP packets received and transmitted by the switch.
Default
Format debug lacp packet
Mode
A sample output of the trace message is shown below.
<15> JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %%
Pkt TX - Intf: 1/0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key:
0x36
no debug lacp packet
This command disables tracing of LACP packets.
Format no debug lacp packet
Mode
debug mldsnooping packet
Use this command to trace MLD snooping packet reception and transmission. receive traces
only received MLD snooping packets and transmit traces only transmitted MLD snooping
packets. When neither keyword is used in the command, then all MLD snooping packet
traces are dumped. Vital information such as source address, destination address, control
packet type, packet length, and the interface on which the packet is received or transmitted is
displayed on the console.
Default
Format debug mldsnooping packet [receive|transmit]
Mode
Format debug ipv6 pimsm packet [receive|transmit]
Mode
Privileged EXEC
Privileged EXEC
disabled
Privileged EXEC
Privileged EXEC
disabled
Privileged EXEC