NETGEAR ProSafe GSM7224P - Show Datacenter-Bridging Priority-Flow-Control

Switching Commands
222
ProSafe Managed Switch
Additionally, the mapping of class-of-service levels to 802.1p priority values to must be set to
one-to-one.
Format
datacenter-bridging priority-flow-control priority
priority-list {drop | no-drop}
Mode
Default
show datacenter-bridging priority-flow-control
This command displays a summary of the priority flow control configuration for a specified
interface or all interfaces.
Format
show datacenter-bridging priority-flow-control [interface
<unit/slot/port>]
Mode
(Switch) #show datacenter-bridging priority-flow-control
Port Drop No-Drop State Priorities Priorities
---- ---- ------ -------- -------
1/0/1 1-4,7 5,6 Enabled
1/0/2 1-4,6-7 5 Enabled
….
1/0/48 1-4,7 5,6 Enabled
Interface Config
drop
Privileged EXEC